Macports gcc2/26/2023 ![]() ![]() :info:build /opt/local/var/macports/build/_opt_local_var_macports_sources_macports_math_paradiseo/paradiseo/work/paradiseo-1.3_beta2/paradiseo-eo/src/eoFlight. :info:build       operator ()(_pop,i) 7 (Lion) is 64-bit and some of the macports packages are only 32-bit. :info:build /opt/local/var/macports/build/_opt_local_var_macports_sources_macports_math_paradiseo/paradiseo/work/paradiseo-1.3_beta2/paradiseo-eo/src/eoVelocity.h:50:13: error: use of undeclared 'operator()' File->New Project->C Project (not C++) and create a hello world project. sudo port select -list gcc and set it sudo port select -set gcc with mp-gcc. Enable 'Make ToolChain (s) Preferred' in Eclipse->Preference->C/C++->New C/C++ Project Wizard. :info:build /opt/local/var/macports/build/_opt_local_var_macports_sources_macports_math_paradiseo/paradiseo/work/paradiseo-1.3_beta2/paradiseo-eo/src/eoParticleBestInit.h:45:13: error: use of undeclared 'operator()' The final steps that worked for openmp, macports gcc compiler, eclipse CDT in mac osx mavericks are. Here are the three errors from the log file: The process was going OK (building, that is) but failed with paradiseo. dmg downloaded from, so that my /opt at the upper levels looks like this: It turns that I had some time back installed Open Modelica using a. To install gccselect, paste this in macOS terminal after installing MacPorts. It symlinks the standard compiler executables in the MacPorts prefix to the selected version.   /opt/openmodelica/Library/LaunchAgents/ gccselect installs files that allow 'port select' to switch the default version of gcc. ![]() ![]() I looked at /Library/LaunchAgents/ and found that it is an alias that pointing to Use 'port -f activate dbus' to force the activation. The installation failed with this error so that dbus and several other dependencies were not installed:Įrror: Target returned: Image error: /Library/LaunchAgents/ already exists and does not belong to a registered port. Unable to activate port dbus. Binaries /Packages with GEOS for other Unix systems: MacPorts may be used to. (Spyder is a python IDE for technical computing.) using GCC or any other supported compiler. A little later I deleted /opt/openmolica and some associated files and did a fresh installation of MacPorts and py-spyder. Here is part of the exchange I had with the macports people. BTW, the problem I had installing MacPorts and then py-spyder on April 2, 2012, was apparently caused by an incompatibility from the binary installation of OpenModelica on September 20, 2011. You are going to install the gcc C compiler (provided by MacPorts), which is preferred for installing Fokko and atlas. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |